Publicité
Les langues disponibles
Les langues disponibles
USING THE REMOTE CONTROL
SETTING THE CLOCK
Inserting
batteries
Detach the battery cover on the rear of the remote control
and
insert two R03 (size AAA) batteries.
.;'0;8
&>"
yo&
1</
q,
e
'""""'"
Q
o
R03 (AAA)
When
to replace
the batteries
The maximum
operational
distance
between
the remote control
and the sensor on the CD player unit should be approximately
5
meters
(16 feet).
When this distance
decreases,
replace
the
batteries
with new ones.
Opening
and closing
the top cover
When
to use the remote
control
Some operations
can be performed
using the buttons
on the
remote
control
only, while others can be performed
using the
buttons on the two main units as well as on the remote control.
This instructions
manual clearly describes
the buttons available
for each operation.
m
If the unit is not going to be used for an extended
period of
time,
remove
the batteries
to prevent
possible
electrolyte
leakage.
The remote control
may not operate correctly
when:
- The line of sight between
the remote control and the remote
sensor (see the illustration
on the previous
page) is exposed
to intense
light, such as direct sunlight.
- Other remote controls
are used nearby (television,
etc.)
w
————-
CJLJL.JU
00
c1
–=
i
~aa
Oo(joo"
{'l._
..__. ._
–-J
SHIFT
To use the SHIFT
button
Buttons
O have two different
functions.
One of the functions
is
indicated
on the button,
and the other on the plate above the
button.
To use the function
on the button, simply press the button.
To use the function
on the plate above
the button,
press the
button while pressing
the SHIFT button.
1
2
3
4
5
6
7
00
0
00
POWER
Press the POWER button to turn on the power.
Press the CLOCK
button while pressing
the
SHIFT button on the remote control.
Within 4 seconds, press the I ~ button.
The hour flashes,
To restore the 12-hour standard,
p~ess the
button again.
Press the <+
or b+
button to designate
the
hour.
Press the 11 button to set the hour.
The hour stops flashing
and the minute starts flashing.
Press the ++
or B+
button to designate
the
minute.
Press
the II
button
to set the minute
and
complete the setting.
The minute stops flashing
on the display and the clock starts
from 00 seconds,
To display
the current
time
Press the CLOCK
button while pressing
the SHIF:T button on
the remote control.
The time is displayed
for 4 seconds.
If the clock
display
flashes
while
the power
is off
This is caused
by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
12 hours, all
settings
stored in memory
after purchase
need to Ibe reset.
ENGLISH
7
Publicité
