Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
TROUBLESHOOTING
GUIDE
Occasional
care and maintenance
of the unit and the software
are needed to optimize
the performance
of your unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces
are extremely
dirty,
use a soft cloth
lightly
moistened
with mild detergent
solution.
Do not use strong
solvents,
such as alcohol,
benzine
or thinner
as these
could
damage
the finish of the unit.
Care of the units
Do not give the units a strong shock ie. drop or hit.
Do not use the units close to a strong magnetic
field such as a
television.
Doing so may cause malfunctions.
Care of CDs
c
When a disc becomes
dirty, wipe the disc from the center out
with a cleaning
cloth.
After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
If the unit fails to perform
as described
in these
Operating
Instructions,
check the following
guide.
GENERAL
There is no sound.
Is the AC cord connected
properly?
Is there a bad connection?
(+ page 4)
Was an incorrect
function
button pressed?
Sound
is emitted
from
one speaker
only.
Is the other speaker
disconnected?
Sound
becomes
inaudible
suddenly.
+ The protection
circuit was activated
due to an internal
heat
build-up.
Turn off the power, make sure there is sufficient
clearance
behind the ventilation
openings
on the rear, and
leave the system
until it cools down.
An erroneous
display
or a malfunction
occurs, or an error
message appears.
+
Reset the system
as stated below.
TUNER SECTION
There is constant, wave-like static.
Is
the antenna
connected
properly?
(+ page 5)
Is the signal weak?
~ Connect
an outdoor
antenna.
The reception contains noise interferences or the sound is
distorted.
Is the system
picking
up external
noise or multipath
distotiion?
+ Change
the orientation
of the antenna.
-+ Move the system
away from other electrical
appliances.
CD PLAYER SECTION
The CD player does not play.
Is
the disc correctly
inserted?
(+ page 11)
Is the disc dirty? (+ page 16)
IS the lens affected
by condensation?
+ Wait approximately
one hour and try again.
To reset
If an unusual
condition
occurs
in the display
window,
reset the
system
as follows.
1 Press the POWER
button to turn off the power.
2
Press the POWER
button to turn the power back on while
pressing
the
button.
Everything
stored
in memory
after
purchase
is canceled.
If the power
cannot
be turned
off in step
1 because
of a
malfunction,
reset by disconnecting
the AC cord and repeat step
-
16
ENGLISH
Publicité
