Publicité
Les langues disponibles
Les langues disponibles
1. Remove Underbody Panel - Using a flat pry tool, remove (12) push-pin fasteners; using a 10mm socket remove (3) hex nuts; using a 14mm socket loosen (1)
plastic hex nut and remove the panel.
2. Install Spacer Plates – Install Spacer Plates onto outer surface of frame
rails. Align holes in Spacers with weldnuts in Frame. Secure Spacers in
position with tape.
©2024 Horizon Global Corporation- Printed in México
3a. Install hitch – Raise hitch into position carefully moving around the
orange power wires and hoses. NOTE: BE CAREFUL, DO NOT DAMAGE
WIRING IN AREA OF HITCH. See Figure 3.
Sheet 4 of 18
76648NP
6-12-24
Rev. A
Publicité
