SilverCrest SOR 2400 D2 Instructions D'utilisation Et Consignes De Sécurité page 11

˜ Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward (see fig . A) .
Place the U shape castor assembly
over the U shape bolt
pointing upward (see fig . B) . Ensure both
threaded ends of U shape bolt
through both holes on the U shape castor
assembly .
11 ] [
Fasten wing nut
[ 8 ]
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins (see fig . C) .
Set the product back to upright position,
wheels on the floor . It is now ready to use .
NOTE: The product is equipped with a
tilt protection switch . It will shut down the
product automatically if it falls over or is lying
on its side .
˜ Operation
Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
"0" respectively .
12 GB/IE/NI
upper than
7 ] [
(see fig . A) .
3 ] [
to the product
[ 10 ]
[ 11 ]
with both wheels
10 ] [
passing
10 ] [
securely onto each
.
10 ] [
9 ] [
attached between
[ 10 ]
.
[ 7 ]
3 ] [
are set to MIN and
[ 2 ]
Connect the product to a grounded mains
socket protected by a residual current circuit
breaker . Ensure that the mains voltage of
the electrical outlet meets the requirements
described in the "Technical data" chapter .
NOTE: Ensure the mains plug is fully
inserted to the mains socket .
˜ Reaching the decided
room temperature
Set the temperature control
the heat level switch
indicator lights up .
[ 1 ]
When the desired room temperature is
reached, turn the temperature control
gently counter-clockwise until the product
shuts off, a "click" sound is heard and the
power indicator
1 ] [
temperature control
the room temperature is now retained . The
product automatically cycles on and off to
keep the decided room temperature, the
power indicator
[ 1 ]
off to indicate when the product is heating
up . As long as the heat level switch
to "1"/"2"/"3", the product operates even
when the power indicator
Use the heat level switch
quickly the product shall warm up . To warm
up quickly, set the heat level switch
"3" .
˜ Turbo heating
To heat the room more quickly, set the
temperature control
heat level switch
2 ] [
indicator lights up .
1 ] [
to MAX . and
[ 3 ]
to "3", the power
2 ] [
[ 3 ]
goes off . Leave the
at the position and
3 ] [
light also cycles on and
is set
[ 2 ]
is off .
[ 1 ]
to select how
[ 2 ]
to
2 ] [
to MAX . and the
[ 3 ]
to "3", the power