Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4) Subsequently, increase the load (in any case following that which is described in the instruction booklet regarding
the maximum load) and if possible keep long periods of lighting, avoiding, at least in this initial phase, brief cycles
of lighting-shutdown.
5) During the first lightings, no object must be set on the appliance and in particular on the enamelled
surfaces. The enamelled surfaces must not be touched during heating.
6) Once the "road test" has been passed, your product can be used like a car engine, avoiding brusque heating with
excessive loads.
ATTENTION: during the first lightings there could be a solid smokes condensation with a small escape of
water from the thermo-fireplace: this event will expire in a very short time but if it persists it will be
necessary to check the chimney draught.
IMPORTANT: Only after a few days of operation (the time necessary for determining that the appliance is
operating correctly), you can begin to assemble the aesthetic facing.
10.
NORMAL OPERATION
After positioning the air register correctly, insert the hourly load of wood (see Chapter 17), avoiding overloads that
could cause anomalous stresses or deformation.
Failure to observe this rule will void the warranty.
The heat emission is regulated with the register situated on the front of the appliance, which should be opened
according to your heating needs. The regulation of the register necessary for obtaining the nominal heat output with
depression to the chimney of 17 - 20 Pa (= 1.7 – 2 mm of column of water) is as follows:
In the event that the water temperature exceeds the tripping temperature of the safety devices, immediately
suspend the feeding of wood, and make sure that the water temperature and the flame decrease, eliminating
the causes of the overheating (if necessary by closing the air register).
If the water system is connected in the thermo-fireplace, the hot water tap can be opened to speed up the
cooling of the appliance.
The combustion intensity and therefore the heating output of your appliance are influenced not only by the regulation
of the combustion air but also by the chimney. Good draught requires a more reduced regulation of the combustion
air, and poor draught requires a more precise regulation of the combustion air.
To verify efficient combustion, check that the smoke coming out of the chimney is transparent.
If the smoke is white, it means that the appliance is not regulated correctly or that the wood is too damp; if the smoke
is grey or black, it means that combustion is not complete (a greater quantity of secondary air is needed).
Never overload the thermo-fireplace.
Too much fuel and air for the combustion can cause overheating and therefore damage ther thermo-fireplace.
The damages caused by overheating are not covered by guarantee.
The thermo-fireplace must always be used with closed door to avoid the forge effect.
11.
OPERATION IN THE TRANSITION PERIODS
ATTENTION: never light for any reason if the installation is not completely full of water in order to avoid a
serious damage of the whole structure. The installation must always be full of water even when the
thermo-fireplace is not used. A possible no use during winter season must be faced by adding antifreeze
substances.
During transition period when the external temperatures are higher, if there is a sudden increase of temperature it can
happen that the combustion gas inside the flue are not completely sucked up. The exhaust gases do not come out
completely (intense smell of gas).
In such case, shake the grille frequently and increase the combustion air. Subsequently load a reduced quantity of
fuel in order that it burns very fast (with expansion of flames) so that the flue becomes regular.
Then check that all the openings for cleaning and the chimney connections are hermetically sealed.
28
Flat
Prismatic
Fuel
Primary air
Wood
Open
Wood
Open
Termocamino 650 – 800
6098000 – EN
Publicité
Table des Matières
