Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The solid combustion residues (ashes) must be collected in a metal container that is hermetically sealed and fire
resistant. The appliance must never be lit in the presence of gaseous emissions or vapours (for example: glue for
linoleum, petrol, etc,). Do not place flammable materials in the vicinity of the appliance.
During the combustion, thermal air is emitted by involving the heating of areas, door and glass hearth, of the door
handles or controls, of the smokes pipe and, in case, of the front part of appliance. Avoid to touch those parts without
a protective clothing or without accessory tools (gloves resistant to heat, control devices).
Instruct the children to achieve those dangers and keep them out from hearth during its operation. touched.
When using the wrong fuel or one which is too damp, due to deposits present in the flue, a flue fire is possible.
Ensure children are aware of these dangers and keep them away from the furnace when it is on.
4.1.
EMERGENCY PROCEDURES
If a fire breaks out in the chimney or in the flue:
a) Close the loading door.
b) Close the combustion air registers.
c) Extinguish the fire using carbon dioxide extinguishers (powdered CO
d) Call the FIRE BRIGADES immediately.
DO NOT ATTEMPT TO EXTINGUISH THE FIRE USING JETS OF WATER.
When the flue stops burning, have it checked by a specialist to identify any cracks or permeable points.
Floor protection with non-
combustible material
Floor made of
combustible material
4.2.
PROTECTING THE BEAMS
Considering the irradiation of the hearth, pay particular attention to protecting the beams when designing your
fireplace. Keep in mind both the proximity of the beams to the external faces of the hearth, and the irradiation of the
glass door, which is normally very close to the beams. In any case, remember that the internal or lower faces of this
beam in combustible material must not be in contact with temperatures above 65 ° C.
CAUTION: The manufacturer cannot be held liable for poor operation of the system that does not conform to
the regulations given in this manual or for the use of unsuitable accessory products. Picture 6 shows
some examples.
(1)
(3) 10 mm
(2)
(3) 10 ÷ 50 mm
(1)
(3) 10 mm
(2)
(1) Beam (2) Refractory material insulation (3) Air gap (4) Metallic protection
22
A
A=Lateral limit of the protected zone (A=H+20 cm=> 40 cm)
B=Frontal limit of the protected zone (B=H+30 cm=> 60 cm)
(1)
(3) 10 mm
(3) 10 mm
(2)
(4)
(1)
(3) 10 mm
(2)
(2)
Height of hearth
surface from floor
H
B
(1)
(2)
(1)
(4)
Termocamino 650 – 800
).
2
Picture 5
Picture 6
6098000 – EN
Publicité
Table des Matières
