Publicité
Les langues disponibles
Les langues disponibles
en - Installation notes
8
Slow or obstructed drainage or a backup of water in the drum as a re-
sult of undersized pipework can result in faults occurring during pro-
gram sequences, which will result in fault messages appearing in the
machine display.
Outflowing suds can be as hot as 203°F (95°C). Danger of injury
by burning!
Avoid direct contact.
Dispenser pump connections
Up to 12 dispenser pumps can be connected to the washing ma-
chine.
Dispenser pump connections on the back of the machine
Connections 1 and 2 are provided for viscous agents and can also be
used for high-pressure dispensing systems with water injection.
These connectors are sealed and need to be drilled open using an
8 mm drill bit before connecting.
Care must be taken to drill through the first wall only (I) as there is a
deflecting panel (II) 3/8" (10 mm) behind it.
Connections 3 to 12 are for liquid detergent. These connectors are
sealed and must be cut to the diameter of the hose with a small saw.
If opened connectors are no longer required, they must be resealed
using a suitable sealant (e.g., silicone).
Connection terminals for five time-controlled dispenser pumps, which
can be operated without a multifunction module, are located behind
the cover adjacent to the electrical connection.
Publicité
