Kärcher K 4.84 MD Mode D'emploi page 14

Operation with detergent
We recommend the Kärcher cleaning and
care program that will match the respective
cleaning requirements. Please seek con-
sultation or request information on the sub-
ject.
Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position -
low pressure.
Fill the detergent solution in the deter-
gent tank (observe dosage instructions
on the packaging of the detergent).
Adjust the suction volume of the deter-
gent solution by means of the dosage
regulator for detergents.
Recommended cleaning method
Spray the detergent sparingly on the dry
surface and allow it to react, but not to
dry.
Spray off loosened dirt with the high-
pressure ray.
Interrupting operation
Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
Insert the trigger gun in its holder.
Finish operation
Caution
Only separate the high-pressure hose from
the trigger gun or the appliance while there
is no pressure in the system.
After working with detergent, suspend
detergent suction hose in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and
rinse until water runs clear.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
14
English
Detach the appliance from the water
supply.
Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
Lock the lever on the trigger gun.
Pull out the mains plug.
Roll up the power cord and loop it e.g.
round the handle.
Insert the trigger gun in its holder.
Stow away the accessories in the ac-
cessory holder.
Maintenance and care
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Maintenance
The appliance is maintenance-free.
Storage
Prior to longer periods of storage, e.g. in the
winter:
Completely drain all water from the ap-
pliance: Switch the appliance on with
detached high-pressure hose and de-
tached water supply (max. 1 minute)
and wait, until no more water exits at the
high-pressure connection. Turn off the
appliance.
Remove filter from suction hose for de-
tergent and clean under running water.
Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.