Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
CONTENTS OF PARTS BAG
1 - Owner's Manual
1 - Parts Bag
(Not shown actual size)
1 - Screw
1 - Key
WARNING: Always wear safety
glasses or eye shields while as-
sembling snow thrower.
TO ASSEMBLE THE HANDLE
1. Remove wrap on upper handle and along
the side of both handles. Discard wrap.
2. Loosen the tee knobs on each side of the
upper handle.
3. Raise the upper handle to the operating
position as shown in the figure above.
Hold upper handle apart to prevent
scratching lower handle.
NOTE: Make sure the control switch
Chute Deflector
F-041020C
ASSEMBLY
1 - Nut
1 - Plastic Tie
Tee Knob
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton.
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side of
the snow thrower are from the viewpoint of
the operator's position behind the unit.
TO REMOVE SNOW THROWER
FROM CARTON
1. Remove the inserts positioned around
the unit and the packing material.
2. Cut down all four corners of the carton
and lay the panels flat.
3. Pull snow thrower out of the carton.
cord and pigtail are not caught be-
tween upper and lower handle.
4. Tighten the tee knobs. Make sure pigtail
is free from the control switch cord.
5. Secure control switch cord to handle us-
ing plastic tie found in plastic bag. Thread
the pointed end of the tie through the
square end. Pull tie tightly around the
cable and handle, after securing clip ex-
cess from tie.
Chute Control
Rod
Tee Knob
7
Control Switch
Lever
Control Switch
Control Switch Cord
Tie
Pigtail
Figure 1
Publicité
