Astralpool PAR 56 Manuel D'installation Et D'entretien page 4

3. Dismantle the parts of the projector required to remove the incandescent lamp (this operation is fully described in
the projector manual).
4. Loosen the two screws which electrically connect the PAR 56 incandescent lamp.
5. Place the PAR 56 led lamp electrically connecting it with the two connection screws.
6. Assemble the projector in its initial position (this operation is fully described in the projector manual).
7. Connect the projector to the mains.
5. MAINTENANCE:
This lamp does not require any type of maintenance work. If you notice that the lamp is not working properly, please
contact our customer attention service.
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED BY
THE USER. IT IS FORBIDDEN TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE
6. CONTROL SYSTEMS OF THE LED LAMP:
This lamp has been designed to operate only with a DMX control and DMX modulators from AstralPool (code 41107). It
will not work with any other control system.
The PAR56 DMX lamp uses 3 DMX channels, one for each of the 3 primary colours (red, green and blue). The
configuration of the DMX address should be performed from the modulator. One modulator can control a maximum of
15 lamps. For independent control, each lamp should have its own transformer and modulator.
modulators should be assigned channels that do not overlap with other modulators.
The lamp is controlled through a DMX modulator, which receives orders from a DMX controller (for example Astral DMX,
41329 or Astral DMX Pro 41330 controllers) and transmits them to the lamp. The Astral DMX or Astral DMX Pro
Interface is connected to all the DMX terminals (e.g. DMX modulator code 41107) of the installation through the DMX
cable (code 41646) as shown in the figure below. All the DMX terminals are connected in series using a single
communications bus. The last DMX terminal of the line should be configured (see DMX line termination) to indicate
that it is the last terminal of the communications bus.
The lamp will remain off while it does not receive a control signal from the DMX controller of the system.
Example of system with DMX modulators for projectors with a PAR56 lamp and DMX feeders (code 41106) for mini
LED projectors (code 32380):
PRODUCT WILL BECOME INVALID.
4
The different