Important; General Characteristics - Astralpool PAR 56 Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions
before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the PAR56 DMX LED Lamp, follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
•
PAR 56 Led lamp
• Installation and maintenance manual

2. GENERAL CHARACTERISTICS:

This lamp has been designed to be used fully submerged in freshwater. It is a Class III electric apparatus with very low
safety voltage (12 V with alternating current). The lamp is class 116, in accordance with standard EN 50065.
The floodlamp complies with IPX8 degree of protection at a nominal immersion depth of 2 m.
This floodlamp complies with international safety standards for lights, especially the EN 60598-2-18 standard: LIGHTS
PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
You should ensure that the voltage received by the lamp is never more than 12 V.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• In order to clearly light a pool It Is recommended lo Install a lamp every 20 m² of water surface. In swimming pools
which are especially deep, an amp is required for every 25 m³ of water volume.
• The connection boxes should be at least 2 m. from the edge of the swimming pool or water installation.
• The 230/12V transformer supplying the lamp, should be installed 3.5 m. from the edge of the swimming pool or
water installation.
• Conduits installed less than 3.5 m. from the swimming pool edge, should not be lined or covered in metal.
THE HOLES AT THE BACK OF THE LAMP (FIG. 1) SHOULD BE LEFT FREE WHEN ASSEMBLING THE PROJECTOR,
SO THAT WATER CAN FLOW INSIDE FOR OPTIMUM PERFORMANCE OF THE LAMP.
The lamp should only operate when submerged and fixed to the vertical walls of the swimming pool. The lamp is
supplied with heat protection for excess temperature, to reduce the level of lighting in order to avoid overheating.
Do not install the 12V ~AC power lines of the lamps and modulators near possible electrical interference of other
signals.
It is necessary to install a
modulator for each one of the
existing transformers
installation.
In installations with long lengths
of power lines,
recommended to lengthen the
230V ~AC line and install the
transformers near the projectors,
and if necessary, lengthen the
12V~AC line towards the DMX
modulator (code 41109), which
controls the projectors:
in the
it is
A T T E N T I O N
2
Projector line
Modulator line