Chauvin Arnoux PEL113 Guide De Démarrage Rapide page 6

INSTALLATION OF THE COLOUR-CODED IDENTIFIERS
For polyphase measurements, mark the current sensors, the voltage leads, and the terminals using the coloured rings
and inserts provided with the instrument, assigning one colour to each terminal.
■ Detach the appropriate inserts and place them in the holes above the terminals (the large ones for the current
terminals, the small ones for the voltage terminals).
■ Clip a ring of the same colour onto each end of the lead that will be connected to the terminal.
INDICATORS
Indicators and colour
REC
Red indicator
Green indicator
Red indicator
OL
Red indicator
Red/green indicator
Orange/red indicator
Green indicator
Recording status
Indicator off: no recording pending or in progress
Indicator blinking: recorder on standby
Indicator lit: recording in progress
Wi-Fi
Indicator off: Wi-Fi link de-activated
Indicator lit: Wi-Fi link activated but not transmitting
Indicator blinking: Wi-Fi link transmitting
Phase order
Indicator off: phase order OK
Indicator blinking: phase order incorrect.
Overload
Indicator off: no overload on the inputs
Indicator blinking: at least one input is overloaded, a lead is missing or is connected
to the wrong terminal
SD card
Indicator lit green: the SD card is OK
Indicator blinking red: SD card being reset
Indicator blinking red and green: the SD card is full
Indicator blinking light green: the SD card will be full before the recording in progress
ends
Indicator lit red: the SD card is missing or locked
Battery
Indicator off: battery fully charged
Indicator lit orange: battery charging
Indicator blinking orange: battery being recharged
Indicator blinking red: battery low (and no mains power)
Power supply
Indicator lit: the instrument is supplied by a mains voltage
Indicator off: the instrument is supplied by the battery
Description