Registers And Frames; Configuration And Installation; Wiring The Digital Input Via The Terminal Block - ADEUNIS LoRaWAN COMFORT CO2 Guide Utilisateur

LoRaWAN COMFORT CO2 - Guide utilisateur / User guide version V1.1.1

3. REGISTERS AND FRAMES

To know the content of the registers and of each frames (uplink and downlink) of the product, refers to the TECHNICAL REFERENCE MANUAL of
the LoRaWAN COMFORT CO2 product, available on the Adeunis website:

4. CONFIGURATION AND INSTALLATION

FR
To configure the product, it is recommended to use the IoT Configurator (android and Windows application).
- Google Play: https://play.google.com/store/apps/details?id=com.adeunis.IoTConfiguratorApp
- Windows 10: https://www.adeunis.com/telechargements/
To configure the product using AT Command or radio recommendations, please refers to the INSTALLATION GUIDE adeunis® available on the
website.
EN

4.1. Wiring the Digital Input via the terminal block

In order to be able to combine a dry contact sensor with the device and thus benefit from its Digital
Input, it is necessary to connect the sensor to the terminal block of the card.
Connection procedure for the wires:
1. Open the unit
2. Plug the two wires into each notch of the terminal block
3. Break the element of the casing so as to pass the wire onto the back of the casing
4. Configure the digital input alarm
5. Close the unit
6. Restart the device with the button as for a first start
After this procedure the device will behave as during a first start
E.g.:
The LoRaWAN COMFORT CO2 device can easily be combined with a cabled door contact via the
terminal block (Digital Input). Thus, positioned next to the door of a secure room under control, the
device will be able to send an alarm every time the door is opened/closed and thus enable the security
manager or the building manager to verify compliance with the security requirements on the site.
https://www.adeunis.com/en/produit/co2-temperature-humidity/
Page 68 of 69