Sensor Installation Recommendations; History Of The Document - ADEUNIS LoRaWAN COMFORT CO2 Guide Utilisateur

LoRaWAN COMFORT CO2 - Guide utilisateur / User guide version V1.1.1

4.2. Sensor installation recommendations

Recommended installation for tertiary and domestic use:
- Hanging on a wall at a height of 1,5 meters from the ground, in a non-enclosed area.
- Placed on a furniture at 1 meter from the ground.
In order to obtain a good measure of the indoor air quality, adeunis advise you to follow the following instructions:
- Do not use the sensor for an outdoor usage.
- Do not install the device in front of the sun, next to a heating or cooling source, next to a ventilation or in a draft.
- Keep one meter from a door or a window.
- When installed on a furniture, be careful to avoid positioning in the direct proximity of a human.
- Do not install the sensor too close from the ground (less than 30 cm).
- Do not install the sensor in a dusty zone or a not maintained zone (garage, cellar, workshop..).
- Do not install the sensor in a room with a relative humidity overpassing 95%RH regularly (bathroom, spa, locker room, laundry room..)
- Do not install the sensor in a zone where it can be damaged or pulled off.
PAY ATTENTION: the front face of the device (enabling the opening of the casing) should be accessible with a screwdriver. Do not install the
device close to the ceiling or under an object at the risk of not being able to open the case.

5. HISTORY OF THE DOCUMENT

Version
V1.1.1
Content
Creation
FR
EN
Page 69 of 69