Operation Of The Leds - ADEUNIS LoRaWAN COMFORT CO2 Guide Utilisateur

LoRaWAN COMFORT CO2 - Guide utilisateur / User guide version V1.1.1

2.12. Operation of the LEDs

Mode
Product in PARK mode
Long push button (5 sec) in PARK mode
Product start (after detection of the push
button)
COMMAND mode
JOIN process (LoRaWAN)
JOIN process: JOIN ACCEPT
Network quality test - running
Network quality test - result
Sensor calibration - running
Sensor calibration - done
Short press-button (<500 ms) in
PRODUCTION mode (event detection)
Long press-button (> 1s) in PRODUCTION
mode (manual calibration)
Low battery level
Product faulty (return to factory)
* The green and red LEDs ON simultaneously give a white/yellow rendering through the casing.
LEDs scenario for a sensor configured in Class A OTAA:
JOIN process :
LED blink successively LED blink successively
every seconds
Red LED State
Off
-
-
Fixed*
Flashing: 50ms ON / 1 s OFF
Flashing: 50ms ON / 50ms OFF (6x)
10 to 20 seconds ON*
Test result is good = Off
Test result is medium = ON 10 seconds*
Test result is bad = ON 10 seconds
Green ON 100 ms, Orange* ON 100ms and Red ON 100ms then OFF 5 seconds
5 times: Green ON 100 ms, Orange* ON 100ms and Red ON 100ms then OFF 2 seconds
ON during the push-button*
-
Flashing: 500ms ON every 60s
Fixed ON
JOIN ACCEPT : Network test:
LEDs fixed during
every 50 ms 10 to 30 seconds
Green LED state
ON from detection of the event during almost
1 second
Rapid flashing:
6 cycles 100ms ON / 100ms OFF
Flashing: 50ms ON / 1 s OFF
(after red LED)
Flashing: 50ms ON /50ms OFF (6x)
(avant LED rouge)
Test result is good = ON 10 seconds
Test result is medium = ON 10 seconds*
Test result is bad = Off
ON during the push-button*
-
-
10 sec
Network test result:
During 10 sec,
Green = Good,
Orange = Medium,
and Red = Bad
FR
EN
CO3 sensor calibration:
The 3 leds green, orange,
red flash successively every 5
seconds during 10 minutes
Page 67 of 69