SilverCrest SLL 16 C1 Mode D'emploi Et Consignes De Sécurité page 21

9.3.1 Activate TWS mode
•
Switch on the speaker that should act as the main speaker. Establish
the Bluetooth
•
Now, switch on the second speaker.
•
Press the
the TWS LED (10) will flash green rapidly for approximately 30
seconds, which indicates the speaker is in TWS pairing mode.
•
Now, briefly press the
the TWS LED on the main speaker is still flashing green. A beep will
sound and the TWS LED (10) will flash green rapidly for
approximately 30 seconds, which indicates the speaker is in TWS
pairing mode.
Two speakers can only be paired with TWS pairing if TWS
pairing mode is activated on both speakers.
•
A beep indicates the coupling was successful. TWS mode is now
active. Playback will now occur through both speakers.
•
The power/charging LED (11) will slowly flash blue and the TWS
LED (10) will flash green twice approximately every five seconds.
The two speakers will switch off automatically after about 30
minutes if no connection is made within that time. The
coupling process must be restarted after switching the
speakers on again. The playback controls
(2) work on both speakers.
®
connection to your smartphone with this speaker.
(6) button on the main speaker. A beep will sound and
(6) button on the second speaker while
SilverCrest SLL 16 C1
(4), (3) and
English - 19