Weller WE1010NA Traduction De La Notice Originale page 15

GB
ENGLISH
Read these instructions and the safety
guidelines carefully before starting up the unit
and starting work.
Failure to observe the safety regulations results in a risk to
life and limb.
Keep these instructions in a place that is accessible to all
users. Please adhere to the operating instructions of the
connected devices.
Safety information
This appliance can be used by chil-
dren aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children shall not play with
the appliance.
Cleaning and user maintenance shall
not be made by children without super-
vision.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
14
WARNING Electrical shock
Connecting the control unit incorrectly poses a risk of
injury due to electric shock and can damage the device.
Carefully read the attached safety information, the safety
•
information accompanying these operating instructions as
well as the operating instructions for your control unit before
putting the control unit into operation and observe the
safety precautions specified therein.
Only connect WELLER tools.
•
If the device is faulty, active electrical conductors may be
bare or the PE conductor may not be functional.
Repairs must always be referred to a Weller-trained
•
specialist.
If the electrical tool's power supply cord is damaged, it must
•
be replaced with a specially prefabricated power supply
cord available through the customer service organisation.
Protect yourself against electric shocks. The handles on
soldering tools with an antistatic design are conductive.
Avoid touching earthed objects such as pipes, heaters,
•
cookers and refrigerators.
Do not use the soldering tool in a damp or wet environment.
•
Never work on voltage-carrying parts.
•
Caution! To provide continued protection against risk of
•
electric shock, connect to properly grounded outlets only.
WARNING Risk of burns
Risk of burns from the soldering tool while the control
unit is operating. Tools may still be hot long after they
have been switched off.
The soldering tip becomes very hot during soldering
work. There is a risk of burns from touching the tips.
After the soldering process, the soldering tool and the
workpiece holder are still hot.
Always place the soldering tool in the safety rest while not
•
in use. Make sure the safety holder is stable.
Do not touch the hot soldering tips and keep them away
•
from inflammable objects..
Only replace solder tips when cold
•
Risk of burning through liquid solder. Protect yourself
against solder splashes.
Wear appropriate protective clothing to protect yourself
•
against burns. Protect your eyes by wearing eye
protection.
When working with adhesives, special attention must be
•
paid to the warning information provided by the adhesive
manufacturer.