Publicité
Les langues disponibles
Les langues disponibles
MOUNTING AND DETACHING THE
SCRAPER BAR
1. Remove the battery pack.
2. Lay the snow shovel on its side or
any other convenient position for
scraper bar service.
3. Use a torx T20 screwdriver (not
included) to remove the four screws
that are located on the scraper bar,
as well as the two screws at both
ends (Fig. 10a & 10b).
4. Replace the worn scraper bar with a
new one.
5. To reassemble, first insert the new
scraper bar, with the six holes
aligned, insert the six screws into
the holes and secure them with a
T20 screwdriver (not included).
56-VOLT LITHIUM-ION CORDLESS 12" SNOW SHOVEL — SNS1200/SNS1200-FC
10a
10b
Scraper Bar
23
Publicité
