Ego Power+ SNS1200 Manuel De L'opérateur page 15

1. Place the snow shovel on the ground and carefully unfold the upper shaft. Make
sure that the cable inside the shaft will not be pinched when closing the hinge.
NOTICE:
If the cable is accidentally pulled out, manually insert the cable back into the
shafts before unfolding.
2. Use the provided 4mm hex key to turn the M5 coupler lock screw clockwise to
lock the shaft.
MOUNTING AND ADJUSTING THE
FRONT HANDLE
1. Make sure the motor is not running
and the battery pack is removed.
2. Loosen the wing nut and remove the
quick-release lever, clamping block,
and wing nut from the front handle
(Fig. 3a).
3. Position the slant of the front handle
upward towards the rear handle.
Press the handle onto the upper
shaft (Fig. 3b).
56-VOLT LITHIUM-ION CORDLESS 12" SNOW SHOVEL — SNS1200/SNS1200-FC
3a
Wing Nut
3b
Quick-release
Lever
Front
Handle
Clamping
Block
15