Publicité
Les langues disponibles
Les langues disponibles
7. CHARGING THE BATTERY
The Dogtra 280C uses Lithium-Polymer batteries.
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable
substances.
3. Fully charge the batteries if the unit is to be stored
without use for a period of 3 months or more.
Recharge the unit if :
1. The indicator light on the collar is emitting a red color.
2. If the 3 bar indicator on the transmitter LCD shows
just 1 bar.
3. The indicator light on the transmitter or receiver will
not come on. The indicator light on the transmitter or
receiver comes on momentarily, but will not stay on
when the "Constant" button is pushed.
Battery Charging Procedure
NOTE : The unit has a partial charge when it leaves the
Dogtra facility, upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use.
18
1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 18.
2. Plug the charger into a 120-volt wall outlet or if using
the accessory field charger, plug into a cigarette
lighter only for Lithium-Polymer batteries. When
properly plugged in, all indicator lights should glow
red. During the charging process, the unit will shut
off. Once the battery cable is unplugged from the unit
after a full charge, you will need to turn the unit on
again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green
light when the battery is fully charged (when you
disconnect the charger after finishing the charge, you
will need to restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers,
and accessories which are compatible with your model
for your Dogtra e-collars. When a charger is not in use,
disconnect it from the power source.
19
Publicité
