Publicité
Les langues disponibles
Les langues disponibles
EN
3.
Remove the remaining spool (3).
1
3
4.
Put the new spool in the spool housing (4).
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5.
Put the end of the cutting line through the eyelet
(5).
6.
Extend the cutting line to release it from the guide
slot in the spool.
English
2
1
4
NOTE
7.
Push the tabs and install the spool cover onto the
spool housing.
8.
Push the spool cover until it clicks into position.
10.4
REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of .065" (1.65
mm) diameter.
1.
Cut a piece of cutting line approximately 3m long.
2.
Bend one end of the line 1/4 of an inch
(6.35mm) .
3.
Insert the line into the anchor hole of the spool.
12
5
NOTE
NOTE
Publicité
