Kärcher NT 65/2 Ap Tc Manuel D'utilisation page 10

Device description
Illustration A
Electrodes
1
Suction hose
2
Push handle
3
Suction head lock
4
Dirt receptacle
5
Removing the
6
Steering roller
7
Suction hose port
8
Tilting chassis
9
Container lock
10
Floor nozzle
11
Container handle
12
Suction pipe
13
Main switch
14
Carrying handle
15
Filter cover
16
Filter dedusting button
17
Hose holder
18
Angle piece
19
Rest for floor nozzle
20
Tilting aid
21
Suction pipe holder
22
Slide
23
Push handle fastening screw
24
Drain hose
25
Type plate
26
Filter dedusting
27
Mains cable
28
Flat fold filter
29
Colour coding
 Control elements for the cleaning process are yel-
low.
 Control elements for maintenance and servicing are
light grey.
Preparation
1. Unpack the device and install the accessories.
Illustration B
Initial startup
ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the flat fold filter when vacuuming.
Dry vacuuming
 An additional paper filter bag can be used when vac-
uuming fine dust.
10
Installing the paper filter bag
1. Unlock and remove the suction head.
2. Connect the paper filter bag.
Illustration C
3. Fit and lock the suction head.
Wet vacuum cleaning
Note
The flat fold filter (cellulose) with the order number
6.904-283.0 included in the scope of delivery is not rec-
ommended for regular wet vacuum cleaning.
Installing the squeegees
1. Remove the brush strip.
Illustration D
2. Install the squeegees.
Removing the paper filter bag
 The paper filter bag must always be removed when
vacuuming wet substances.
 It is recommended to use a special filter bag (wet)
(see filter systems).
Draining the waste water
WARNING
Improper disposal of waste water
Environmental pollution
Observe the local waste water treatment regulations.
1. Drain the waste water via the drain hose.
Illustration E
Draining the container completely
1. Lock parking brake.
2. Hold the container by the handle and tilt it by lifting.
Illustration F
3. Completely drain the container.
4. Tilt the container back into its original position.
5. Release the parking brake.
 We recommend not using the "Semi-automatic filter
dedusting" function button when vacuuming wet dirt
with the crevice nozzle or upholstery nozzle (option-
al) when sucking mainly water out of a container.
 The device switches off automatically when the
maximum fluid level is reached.
 When vacuuming non-conductive liquids (e.g. drill
emulsion, oils and grease) the device does not au-
tomatically switch off when the container is full. The
filling level must be continuously monitored and the
container emptied on a timely basis.
 On completion of wet vacuum cleaning: Clean the
flat fold filter using the dedusting function. Clean the
electrodes with a brush. Clean the container with a
moist cloth and dry it off.
The suction hose is equipped with a clip system. All ac-
cessory parts with a nominal width of 40 mm can be
connected.
Illustration G
Removing/Inserting the container
1. Unlock and remove the suction head.
2. Unhook the drain hose.
3. Pull out both slides.
4. Remove the container upwards.
5. Insert the container in the reverse order.
Illustration H
English
General
Clip connection
Operation