Krüger & Matz KM0815 Mode D'emploi page 25

Owner's manual
TROUBLESHOOTING
Problem
No power
Remote control does not work
poor radio reception
Clock setting erased
No response from the unit
Cannot find Bluetooth name of this
unit on my Bluetooth device
SPECIFICATION
• Bluetooth 3.0
• DAB+ digital radio (band III 174.928 – 239.200 MHz)
• FM Radio
• 20 preset stations memory
• Dual alarm
• Output power: 2x 5 W
• THD: 1% (1 kHz, 1 W)
• Input sensitivity: 500 mV
• Frequency response: 40 Hz – 20 kHz
• Impedance: 2 Ohm
• External devices charging (5 V; 2,1 A)
• I/O:
• USB port (external devices charging)
• Line input
• LCD display
• Remote Control
• power consumption: 25 W
• power supply: 220-240 V; 50/60 Hz
Possible solution
• Ensure that the AC cable is connected
properly
• Ensure that the unit is switched on
• Make sure you selected correct
source
• Reduce the distance between the
remote control and the unit
• Insert the battery with its polarities
(+/-) aligned as indicated
• Replace the battery
• point the remote control directly at
the sensor on the front of the unit
• Increase the distance between the
unit and your TV or VCR
• power has been interrupted or the
power cord has been disconnected
• Reset the clock
• Disconnect and reconnect the AC
power plug, then turn on the unit
again
• Ensure the Bluetooth function is
activated on your Bluetooth device
• Ensure you have paired the unit with
your Bluetooth device
25