Krüger & Matz KM0815 Mode D'emploi page 18

First time use:
The unit has a pre-installed CR2025 battery. Remove the
protective tab to activate the remote control battery.
Replacing the remote control battery:
1. pull out the battery tray and remove the old battery.
2. place a new CR2025 battery into the battery tray with correct polarity (+/-) as
indicated.
3. Insert the battery tray back into the slot.
Installing backup batteries:
1. Open the batteries compartment.
2. Install two AAA batteries (not included)
with correct polarity and the install steps as
indicated.
3. Close the battery compartment.
Notes:
• You can only use AC power as power supply.
Batteries (not included) are for backup
purpose.
• If the system is unplugged or if a power failure occurs, all setup of the unit will
be erased unless there are batteries in the unit and they are not being changed
at this time. Once setup had been erased, please reset all items you desire.
• If the batteries leak, wipe away the leakage inside the battery compartment and
replace the batteries with new ones.
• Do not use any batteries other than those specified.
• Do not heat or disassemble batteries. Never throw them in fire or water.
• Do not carry or store batteries with other metallic objects. Doing so could cause
batteries to short circuit, leak or explode.
• Never recharge a battery unless it is confirmed to be a rechargeable type.
18
2
1
Owner's manual
3
4