Dab Radio Mode - Krüger & Matz KM0815 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
RADIO MODE
Auto Scan and Save Preset Station
1.
press the ON/OFF/SOURCE button on the unit or press the SOURCE button on
the remote control repeatedly to select FM mode.
2.
press and hold the
on the remote control to activate automatic programming. All available
stations are programmed in the order of waveband reception strength.
• The first programmed radio station is played automatically.
3.
press the
Tuning in a Station
Tune in radio stations automatically
press and hold the
automatically until a station is found.
Note: The search may not stop at a station with a very weak signal.
Tune in radio stations manually
press the
Note: If reception is still poor, try to adjust the position of the aerial or try to
move the radio to another location.
Presetting Stations Manually
You can store up to 20 of your favourite stations to the memory.
1.
Tune in the desired station, then press the pROG button.
2.
press the
3.
press the pROG button to store the station.
4.
Repeat the above steps (1 to 3) for each station you want to store in memory
with a preset number.

DAB RADIO MODE

Your DAB radio will automatically tune to all available stations when the unit
switching to DAB mode for the first time.
To retune, or search for new stations, press and hold the
main unit or press the SCAN button to perform a full scan.
To select the DAB station press the
PAIR button on the remote control to confirm.
Manual DAB tuning
In DAB mode press the MENU to enter the DAB menu.
press the
press the
displayed.
press the
the
/pAIR button to start the scan.
22
/pAIR button on the main unit or press the SCAN button
or
buttons to go to the previous/next radio station.
/
/
buttons repeatedly until you find the station you want.
/
buttons to select the preset number.
/
buttons to select MANUAL.
/PAIR to confirm the selection. The DAB radio frequency will be
/
button to select a frequency you want to scan, then press
buttons; the frequency changes down or up
/
buttons and then press the
Owner's manual
/pAIR button on the
/

Publicité

Table des Matières
loading

Table des Matières