General Operation - Krüger & Matz KM0815 Mode D'emploi

Owner's manual
CONNECTIONS
Connect the DAB antenna
• Connect the supplied DAB antenna to
the DAB socket on the rear of the unit
by turning the antenna's screw cap
clockwise. Do not over tighten as this
could damage the antenna.
• To avoid noisy interference, keep
the antenna away from the unit, the
connecting cord and the power cord.
• You may need to reposition the aerial for optimum reception.
• The best position is dependent on the station and the strength of the signal.
Use Line input
Use a 3,5 mm audio cable to connect the
audio player's headphone socket to the
line input on the unit.
Connect power
Connect the AC power cord to the wall
socket.
Notes:
• Ensure that the power supply voltage
corresponds to the voltage printed
on the rating label on the back or the
underside of the unit.
• Be sure to unplug the power cord from
the outlet when the system is not in
use for an extended period of time.
Use USB charging port
Connect a USB cable (not included) to USB port of the device to charge your
smartphone or tablet pC.

GENERAL OPERATION

Standby/ON
When you first connect the unit to the mains socket, the unit will be in STANDBY
mode.
• press the ON/OFF/SOURCE button on the main unit or the button on the remote
control to switch the main unit on. Press this button again to switch it off.
• Disconnect the plug from the mains socket if you want to switch the unit off
completely.
19