Krüger & Matz KM0815 Mode D'emploi page 21

Owner's manual
3. press the CLOCk button on remote control or SNOOzE button on main unit to
confirm.
4. Repeat steps 2-3 to set the minutes.
Note:
• During Time Setup, press the
SETTING THE ALARM TIMER
Before setting the alarms ensure the time shown on the clock is correct.
1. press and hold the ALARM (1 or 2) buttons in standby mode for a few seconds
and the hour digits will flash. Press the
the /
2. Press the ALARM (1 or 2) button and the minutes digits will flash. Press the
buttons on the remote control or the
the minutes.
3. press the ALARM (1 or 2) button again and press the
remote control or the
sound. You can select either FM, DAB or beeps (BUzzER).
4. Press the ALARM (1 or 2) button again and the flashing volume level will be
displayed. press the
buttons on main unit to select the volume level.
Note:
• Set the volume to at least level 5. You can increase the level to ensure the alarm
can be heard.
Activate and Deactivate the Alarm Timer
1. press the ALARM 1 or ALARM 2 button to activate the alarm.
2. The alarms are active when
front of the unit.
3. To deactivate the alarms, press the ALARM (1 or 2) button. The
will disappear from the display on the front of the unit.
Repeat Alarm
You can press SNOOzE/DIMMER button to adjust the interval to repeat alarm. When
the alarm rings, press the SNOOzE/DIMMER button on main unit, the alarm repeats
ringing 9 minutes later.
Stop Alarm Ring
When the alarm rings, press the corresponding ALARM (1 or 2) button. The alarm
stops but the alarm settings remain.
View the Alarm Settings
press the ALARM 1 or ALARM 2 buttons to view the alarm settings.
button to select 12/24 hour format.
buttons on main unit to set the desired hour.
/
/ buttons on the remote control or the
or
/ buttons on the remote control or
/ buttons on main unit to set
buttons on main unit to select an alarm
or both are shown in the display on the
/
/ buttons on the
/
and/or
21