Publicité
Les langues disponibles
Les langues disponibles
2. Fully open the Propane/LPG cylinder knob.
3. Turn starting dial switch to the ON
4. Remote start
Turn and hold the REMOTE START switch for
5 seconds until the engine start.
4. Electric start
Turn and hold the ENGINE START/STOP switch
for 5 seconds until the engine start.
4. Recoil start
Pull recoil starter slowly until resistance is felt,
then pull rapidly.
When starting engine, pull cord slowly until
resistance is felt and then pull rapidly to avoid
position.
kickback.
NOTE:
If engine starts after 3 pulls but fails to run. Or if unit
shuts down during operation, make sure unit is on a
level surface and check for proper oil level in
crankcase. This unit may be equipped with a low oil
protection device. If so, oil must be at proper level
for engine to start.
Connecting Electrical Loads
This unit has been pretested and adjusted to handle
its full capacity. Before starting the generator,
disconnect all loads. Apply load only after generator
is running. Voltage is regulated via the engine speed
adjusted at the factory for correct output.
Re-adjusting will void warranty.
NOTE:
Remote
When applying a load, do not exceed the maximum
wattage rating of the generator when using one or
more receptacles. Also, do not exceed the amperage
rating of any one receptacle.
Do not apply heavy electrical load during break-in
period (the first five hours of operations).
1. Let engine stabilize and warm up for a few minutes
after starting.
2. Ensure circuit breaker on control panel is in on
position.
Electric
3. Plug in and turn on the desired 120 Volt AC, single
phase, 60Hz electrical loads. It is better to attach
the item with largest load first.
Recoil
Page 22
WARNING
Starter cord kickback (rapid retraction)
will pull hand and arm toward engine
faster than you can let go which could
cause broken bones, fractures, bruises,
or sprains resulting in serious injury.
Publicité
