Publicité
Les langues disponibles
Les langues disponibles
en-us Troubleshooting
Issue
Display shows "Fill wa-
ter tank" despite the
water tank being full.
Display shows "Clean
brewing unit".
Display shows "Incor-
rect voltage".
Display shows
"Calc'nClean required!"
very frequently.
Appliance cannot be
operated.
Change displays.
34
Cause and troubleshooting
Water tank is inserted wrong.
Insert the water tank correctly.
▶
Carbonated water is in the water tank.
Fill the water tank with fresh drinking water.
▶
Float is stuck in the water tank.
Remove the water tank.
1.
Clean the water tank thoroughly.
2.
New water filter was not rinsed as per instructions.
Rinse the water filter according to the instructions.
1.
Place the water filter into operation.
2.
Air in the water filter.
Immerse the water filter in water with the opening
1.
facing upwards until no more air bubbles escape.
Reinsert the filter.
2.
Water filter is old.
Insert a new water filter.
▶
Limescale deposits in the water tank are blocking the
system.
Clean the water tank thoroughly.
1.
Start the Calc'nClean service program.
2.
Brewing unit is soiled.
Clean the brewing unit.
▶
Mechanism of brewing unit is stiff.
Clean the brewing unit.
▶
There are problems with the power supply.
Only operate the appliance at 120 V ∼.
▶
Decalcified water still contains small amounts of lime.
Insert a new water filter.
1.
Set the corresponding water hardness.
2.
Incorrect or too little descaling agent used.
When descaling, only use suitable tablets.
▶
Appliance is in demo mode.
To deactivate demo mode, press and hold
1.
for at least 5 seconds.
Remove the water tank.
2.
Fill the water tank with fresh water.
3.
Reinsert the water tank.
4.
button
Publicité
