IFM Electronic EFECTOR 110 G15004 Notice D'utilisation page 15

The unit must be installed, connected and put into operation by a qualified
electrician trained in safety technology.
After installation of the system a complete function check must be carried
out.
Disconnect the unit externally before handling it. Also disconnect any
independently supplied relay load circuits.
The design of the unit corresponds to the protection class II except for the
terminal blocks. Protection against accidental contact (finger-touch to IP20)
is only guaranteed if the terminal screw has been completely screwed in.
For installation the requirements according to EN60204-1 must be observed.
In case of malfunction of the unit please contact the manufacturer.
Tampering with the unit can seriously affect the safety of people and
equipment. This is not permitted and leads to an exclusion of liability and
warranty.
Important notes on the deactivation of the safety function
To carry out certain operations (e.g. muting) the safety function of
the evaluation unit G15004 can be deactivated by means of suitable
wiring measures (e.g. via a keylock switch at the inputs E1/E2 and
E3/E4).
The operator undertakes to allow this operating state only in
conjunction with other measures which exclude a danger to people
(e.g. additional mechanical guard, lower speed of the drives).
These measures are at the operator's own responsibility and should
additionally be approved by respective test organisations.
ifm electronic assumes no liability for damage due to the
deactivation of safety functions.
Seite 15