Nolan N606/SPORT Instructions D'utilisation page 14

N60-6
VISOR ( NFS-06 )
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 Push the release lever of the left side mechanism completely downwards (Fig.1)
and simultaneously push the visor away from the helmet initially projecting the
lower hook "A" and then the top hook "B" from the corresponding seats in the side
mechanism (Fig.2).
1.3 Follow the previous operations on the right side of the helmet.
2 ASSEMBLY
2.1 Position the left side part of the visor on the corresponding side mechanism by in-
serting the top hook "B" of the visor into the corresponding seat in the mechanism
and aligning the lower hook "A" of the visor above the corresponding seat in the
mechanism (Fig.2).
2.2 Press the visor at the lower hook "A" so that the release lever recedes and then re-
turns to position, hooking the visor to the side mechanism with just a click (Fig.1).
2.3 Follow the previous operations on the right side of the helmet.
2.4 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure the latter is held in place in its different positions by the mechanisms.
If necessary, repeat the operations mentioned above.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
( NFS-06 )
(Available as standard or accessory/spare part)
1 ASSEMBLY
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.3).
1.3 Place the PINLOCK
The silicone profile of the PINLOCK
with the inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.4).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.5).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone profile of the inner visor adheres to the visor.
1.8 Fit the visor on the helmet (see instructions above).
14
INSTRUCTIONS FOR USE
inner visor on the visor.
®
inner visor onto one of the two visor pins and hold
®
inner visor inner visor must be in contact
®
inner visor and check that the
®
inner visor to the other
®