Parkside 315586 Traduction Des Instructions D'origine page 194

GB IE
• Only use chargers belonging to
the Parkside X 20 V Team series
to recharge the battery. Risk of
fire and explosion.
• Before each use, check the charg-
er, cable and plug and have them
repaired by qualified profession-
als and only with original parts.
Do not use a defective charger
and do not open it up yourself.
This ensures that the safety of the
device is maintained.
• Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specifications on the charger rat-
ing plate. Risk of electric shock.
• Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
• Keep the charger clean and
away from wet and rain. Do
not use the charger outdoors.
Dirt and the entry of water in-
crease the risk of electric shock.
• The charger may only be
used with the corresponding
rechargeable batteries of the
Parkside X 20 V Team series.
Charging other batteries can
lead to injuries and the risk of
fire.
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to heat-
ing during charging.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
18
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries. The device could become
damaged.
Charging Process
Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
• To recharge the battery, only use a
charger belonging to the Parkside
X 20 V Team series.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.