Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
operations, access the remote control menu in one of the following ways:
1) During a voice call from the BTEL-GT; press the
BTEL-GT ends the call. When the
boop) confirming this; at this point, type in the <User PIN>.
2) By making a call to the BTEL-GT from a telephone number stored in the phone book. After recognizing the
telephone number, the BTEL-GT accepts the call and sounds a double tone (beep-boop) as confirmation;
at this point, type in the <User PIN>.
The <User PIN> is a 5-digit number (the factory default user PIN is 00000).
If no key is pressed within 10 seconds the call is ended. If the <User PIN> you typed in is correct, the BTEL-GT
plays the voice message "CODE ACCEPTED" and after a 2-second pause it begins to play the voice menu; if the
PIN is incorrect, the device will play the voice message "INCORRECT CODE" followed by a single tone (boop).
The maximum number of tries allowed to enter the <User PIN> is 3, after which the BTEL-GT will end the call and
resume its normal operations (for example, delivering a voice message to another number). If the <User PIN>
typed is valid, the User Menu will open, from which you can perform the following operations: Output
Management, Monitor Input, Environment Listen Management, Block Calls, and Change Code.
Dialer Parameters Management
This section is used to manage the main features needed for the BTEL-GT to function.
Output Management
Once you enter this section,the voice instructions start to list the programming for each output.To enter this programming
mode,type the following keypad sequence:
the
key to enable the output or
Monitor Input
To check the active/inactive status of the four inputs (L1, L2, L3, and L4), type the following keypad sequence:
Environment Listen Management
This function can be activated in order to hear what is happening in the protected area through a sensitive
microphone. To enable/disable the open microphone, type the following keypad sequence:
Block Calls
Once you are aware of the situation that caused the alarm, or in case of a false alarm,you can block the dialer (and therefore
any calls or text messages,even those in progress). To do this is sufficient,after entering the user menu,press
CAUTION:
— To block calls, you can also use input no. 4 (L4) when suitably connected and programmed.
— If you enter the User PIN during a call to access the User Menu (yellow LED lit), the key inputs will
not be confirmed by a tone but the code will still be accepted and you will access the menu at the end
of the call. You cannot enter the User PIN at the beginning or end of a call (yellow LED switching).
— If "Call Confirm Result" is enabled, you need to press
having received the voice message and before the dialer ends the call) to confirm reception of the
voice message and not receive any more calls at this number (but without blocking the dialer).
Change Code
The factory default User PIN is 00000. To change it, type the following keypad sequence:
where <New PIN> is a number of 5 digits.
Dial Number
To call a telephone number in live mode, type the following keypad sequence:
GSM Telephone dialler
key is recognized, the BTEL-GT will sound a double tone (beep-
,a voice message will inform the user of the status of the first output (O1).Press
to disable;to exit, press
<New PIN><Repeat New PIN>
key while the message is playing and before the
.The operation is repeated for outputs O2 and O3.
(to Enable)
(to Disable)
or
on a PSTN or GSM telephone (after
G
.
39
Publicité
Chapitres
Table des Matières
