Status Leds - Bentel Security BTEL-GT Manuel D'installation Et D'utilisation

1
Power Supply
13.8 Vdc ±2%
WARNING
Incorrect connections may result in FTC fault or improper operation. Inspect wiring and ensure connections are correct
before applying power. DO NOT route any wiring over circuit boards; maintain at least 1" (24.5 mm) separation.
A minimum 1/4" (6.4 mm) separation must be maintained at all points between Power Limited wiring and all other
Non-Power Limited wiring.
Fig. 3 - Example of connection to the BTEL-GT dialler
On the screen there are 6 LED's; three green LED's, one red LED, one yellow LED, and one red LED, which
show connection, malfunctions, transmission, the status of the BTEL-GT, and programming mode.
     During inizialization, the LED's will flash.
GREEN — The three green LED's show the strength of GSM reception and status (table 5):
The first LED, if ON, shows optimal GSM reception: therefore, it turns on only when the second
and third LED's are also lit.
The second LED. When this LED is ON, the reception is good: this LED turns on only when the third
green LED is lit;
The third LED, if turned OFF, indicates that the GSM network is NOT available. If this LED is lit,
the network signal is low but sufficient for voice calls;
RED — This LED is normally OFF. If it lights up, this indicates a malfunction. The BTEL-GT
checks for tthe presence of some malfunctions (for example, no GSM network or low battery power);
the red LED will remain lit until the malfunction is repaired.
YELLOW - If ON it means a call (either incoming or outgoing) is taking place on the GSM network.
RED - If solid lit it indicates that factory data are being loaded or programming is under way.
28
3 4 5 6
2
+OC
Relay
Tamper line of
the security
system

STATUS LEDS

7 8 9 10 11 12 13 14 15
BTEL-GT