Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Activating an input while the Installer Menu is in operation does not produce voice calls or
programmed text messages; these events are not even placed in the queue for execution after
exiting from the Installer Menu.
Restore Factory Settings
To reset all the factory settings, remove all power supplies from the device, and then press the
keys simultaneously, and reconnect the power supply while keeping the keys pressed for approximately
3 seconds. During this process, the RED LED
Access to Programming Mode
When turned on for the first time, or when restarting because factory settings were reset, the BTEL-GT asks
which language is to be used, as described below:
Press the key for the language to use and to confirm your choice, press the
parameters by keypad, an Installer Code must be entered via the BTEL-GT keypad as follows:
where <Installer Code> is a 5-digit number (the factory Installer Code is 11111). If the code entered is
correct, the Installer Menu will open.
IMPORTANT - Keeping the
PIN; if you become aware that you are typing the wrong PIN, you need to wait a few seconds for the
operation to be canceled automatically, or type the
Access to programming mode is indicated by the RED LED
Parameters Management
In this section you can program the main settings for the BTEL-GT.
Phone Book Management
The dialler is provided from the factory without any programmed telephone numbers.
Write Phone Book
To program a phone number, type the following keypad sequence:
where <Position no.> is a number from
example:
The dialler can memorize up to 9 telephone numbers: each number can consist of 16 digits at most.
Read Phone Book
To read the programmed phone number, type the following keypad sequence:
where <Position no.> is a number from
If, for example, you want the third programmed telephone number displayed (position no. 3 ) type
Delete
To delete the programmed telephone number, type the following keypad sequence:
GSM Telephone dialler
light will be on (see the section "Status LEDs").
<Installer Code>
key pressed for 3 seconds does not cancel the insertion of the Installer
<Position no.> <Telephone number>
to
while <Telephone number> is a number of up to 16 digits. For
(the telephone number saved in the phone book under position no. 1 is 3470).
to
.
= Italian,
= English,
key to finish your entry and then try again.
(see the section "Status LEDs").
<Position no.>
<Position no.>
,
,
= French,
= Spanish
key. In order to program
and
G
31
Publicité
Chapitres
Table des Matières
