Publicité
Les langues disponibles
Les langues disponibles
OPERATION
l Allow the generator output to stabilize. Once stable, the
engine should run smoothly, and the device should function
properly.
l Connect and start the next largest device or appliance.
l Allow the generator output to stabilize.
l Repeat this process for each additional load.
STOPPING THE GENERATOR
See Figures 12 - 13.
l Remove any connected loads from the control panel
receptacles.
l Allow the generator to run at "no load" to reduce and
stabilize engine and alternator temperatures.
l Turn the engine/fuel control switch to the off position
FIG. 12
D
A - Engine/fuel control switch
B - Choke
C - Run
D - Gasoline off
E - Pull recoil handle
18 | English
E
A
B
C
To stop the unit quickly in an emergency:
l Turn the engine/fuel control switch to the off position
LOW OIL INDICATOR
See Figure 13.
The LOW OIL LED on the control panel will illuminate when
the unit is low or out of oil. The generator will not start when
the indicator is lit. To resume normal operation, add engine
oil as described earlier in this section. Do not attempt to
crank or start engine before it has been properly ser-
viced with recommended oil.
ECO MODE
See Figure 13.
NOTICE
Always start the generator with the ECO
mode switch in the OFF position. Allow the engine
speed to stabilize and the OUTPUT READY LED to
illuminate before putting the ECO mode switch in the
ON position.
FIG. 13
D
E
I
F
G
B
C
A - 120 Volt AC 20 amp receptacles
B - 120 Volt AC 30 amp receptacle
C - Parallel operation outlets
D - ECO mode switch
E - Reset button
F - 20 amp circuit breaker
G - USB ports
H - Overload LED
I - 30 amp circuit breaker
J - Output ready LED
H
J
J
A
Publicité
