Standard Accessories; Applications - Metabo HPT C 10FSH Instructions De Sécurité Et Mode D'emploi

When cutting the workpiece which has the dimension of "*" there might be some possibility of the lower end of
the circular saw to touch with the workpiece, even if the motor head is located at the lower limit position. Pay
attention when cutting the workpiece. For further details, refer to "PRACTICAL APPLICATIONS" on page 17. Mount
the auxiliary board on the fence surface (Refer ( ) the thickness of auxiliary board). Refer to "5. Cutting large
workpieces" on page 19 (Fig. 27).
ACCESSORIES
WARNING:
Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and could cause injury
or mechanical damage.

STANDARD ACCESSORIES

1 10" (255mm) TCT Saw blade
(1 piece)
No. of teeth 40 Code No. 310878
(C329701)
OPTIONAL ACCESSORIES
1 Extension Holder and Stopper (Code No. 321553)
2 Saw blade 10"(255mm) TCT Saw blade (Total teeth:72) (Code No. 725206)
3 Crown molding Vise Ass'y (Code No. 321434) (Include Crown molding Stopper (L))
4 Crown molding Stopper (L) (Code No. 321374)
5 Crown molding Stopper (R) (Code No. 321373)
NOTE:
Accessories are subject to change without any obligation on the part of the metabo HPT.

APPLICATIONS

Wood and aluminum sash.
2 Dust bag (1 piece)
For how to use, refer to page 24.
4 10mm BOX wrench
(1 piece)
Fig. 3
...sold separately
3 Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to page 17.
5 Sub table Assembly (2 piece)
For how to use, refer to page 14.
English
9