Cutter Guard Setting; Operation; Tools; Stock Prechecking - Metabo TF 100 M Instructions De Service

13.6 Cutter Guard Setting

C
Loosen starknob (C) and set holddown
shoe onto the workpiece.
Caution!
Switch machine off and let tool come to a complete stop before making any adjustments.
14

Operation

14.1 Tools

This spindle moulder model TF 100 M must only be operated with tools having chip limitors for reduced kickback
and approved for manual feed, e.g. BG-TEST tools or equivalent.

14.2 Stock Prechecking

- Grown timber should be planed prior to any moulding operation.
- Do not work stock that is warped, bend or otherwise does not rest fully over its full length on the table and/or
against the fence plates.

14.3 Moulding Strips

- Mount tool as per section 13.2.
- Set/check spindle speed as per
section 13.3.
- Adjust spindle and fence as per
sections 13.4 and 13.5.

14.4 Moulding Boards

- Mount tool as per section 13.2.
- Set/check spindle speed as per
section 13.3.
- Adjust spindle and fence as per
sections 13.4 and 13.5.
Caution!
Always feed with a pushstick if the workpiece width is less than 120 mm.
Adjust downward pressure with star-
knob (D).
- Adjust cutter guard as per section
13.6 to accommodate
workpiece.
- Start machine and feed the work-
piece with a steady motion slowly
against the rotating tool.
- Remove the cutter guard's pres-
sure spring.
- Set holddlown shoe as described
in section 13.6.
D
After loosening starknob (E) set spring
guide against the workpiece.
Important!
the
Always use a pushblock to feed the
work when near the end.
- Start machine and feed the work-
piece with a steady motion slowly
against the rotating tool.
E