Publicité
Les langues disponibles
Les langues disponibles
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on.
2. Press the Mode button again to choose the next
speed level.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
3 minutes.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
Maintenance
Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop switch works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view. Refer to
power trigger lockout on page 8 .
Make sure that all controls work and are not damaged.
Make sure that the blade and blade guard have no cracks and that they are not
damaged. Replace the blade or the blade guard if they have cracks or if they
have been exposed to impact.
Make sure that the blade is not bent or damaged. Speak to your dealer to
replace the blade if it is necessary.
Make sure that the hand guard is not damaged. Replace the guard if it is dam-
aged.
Make sure that the screws and nuts are tight.
Make sure that the battery is not damaged.
1865 - 004 - 10.05.2024
Maintenance
Read and understand the
Remove the battery before
To do a check of the power trigger and
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED goes
out.
3. Push the release buttons on the battery and pull the
battery out.
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
13
Publicité
