Publicité
Les langues disponibles
Les langues disponibles
proper air ventilation. Adjust the feet to keep the freezer level.
▪
Locate the freezer away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause
the freezer not to perform properly. This unit is not designed for use in a garage or
any other outside installation.
▪ Avoid locating the freezer in moist areas.
▪ Plug the freezer into dedicated, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized service center. This unit is not designed to be installed in
an RV or used with an inverter.
▪ After plugging the appliance into a wall outlet, turn the unit on and allow the unit to
cool down for 2~3 hours under before placing food in the freezer compartment.
Make sure that sufficient room is provided around the appliance to ensure free air circulation.
Ideally, A space of no less than 10cm must be left around the freezer, and ensure you allow
gaps as shown in the below diagram.
When selecting a location for your appliance you should make sure the floor is flat and firm,
and the room is well ventilated. An average ambient temperature must be observed. This
temperature is specific according to the climatic class of the device.
CV99A+ CV142A+ CV198A+ CV295A+ appliances are intended to be used at ambient
temperatures ranging from 10 °C to 43 °C
Publicité
