VINCENT CD-S5 Manuel D'utilisation page 28

10
10. ANALOG OUTPUT:
analogue audio signal outputs
Either one of the RCA connector pairs or the XLR
sockets ("BALANCED") are connected to the rele-
vant input of the amplifier, preamplifier etc. It is
not necessary to also connect one of the digital
signal outputs (11).
11. DIGITAL OUTPUT:
digital audio signal outputs
If the amplifier, receiver or preamplifier is equip-
ped with a digital coaxial or optical digital input
connector, the relevant CD player signal output
may be connected to this. It is not necessary to
connect an analogue (10) and a digital signal
output (11) at the same time.
Vincent
28
REAR VIEW
11
12. POWER CONTROL (12V): ON/OFF control
These jack connectors (3,5 mm) receive and for-
ward the signal for the standby control (12V
Trigger).
13. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a wall
power outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the secu-
rity precautions.
12 13