LGB HSB Kof II Mode D'emploi page 8

Safety Notes
• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.
• This product contains magnets. Swallowing more than one magnet may cause death
in certain circumstances. If necessary, see a doctor immediately.
Important Notes
• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html
Functions
• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• Factory-installed multiple protocol decoder (DC, DCC, mfx).
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: HSB 199 010-0
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
Mode of Operation Switch
This model has a four-position mode of operation switch in the cab (Figure 1).
Pos. 0 Locomotive stopped without current
Pos. 1 Locomotive motors, sound, and lighting are turned on
Pos. 2 & 3 Same as Pos. 1
Sound
This model has a volume controller in the cab (left hand wheel; Figure 2). When you
change the direction of travel, the prototype's noise of the relay changing over is
reproduced.
The whistle can also be activated with the LGB sound activation magnets (17050)
included with this model. The activation magnet can be clipped in between the ties on
most sections of LGB track. The magnet is located to the side under the stamped LGB
logo. Place the magnet with the logo on the right or left side of the track in order to
sound the whistle long or short when the locomotive goes over this spot.
8