SEM FSED Instructions D'utilisation Et Avis De Montage page 28

SEM 5 (dis. 21)
This model has been specifically studied to suction vapours and odours without noise.It should be instal-
led outside and connected to the hood in the kitchen (fig. 16) or to the SCET control unit 1.
Roof installation: make a 22 x 22 cm square opening on the roof, and then insert the lower part of the
remote fitted exhausting motor (fig. 17).
Put the two brackets as shown in fig 18A and mark the holes you are going to drill on the lower part of
the remote fitted exhausting motor.
Make all the holes, and then fasten securely.
Insert the pipe connecting the hood outlet line with the upper part of the remote fitted extraction motor
(fig.19A); the pipe should pass into the lower part of the remote fitted exhausting motor (fig. 19).
Fix the pipe to the upper part of the remote fitted exhausting motor with a metal hose clamp.
Assembly the upper and the lower part of the remote fitted exhausting motor using the 8 screws provi-
ded (fig.19B).
Electrical connection of the hood: the appliance is equipped with a 7m electrical cable. Connect it to
the six-pin connection of the appliance in the kitchen, or to the SCET-1 central unit (see fig. 20).
28