Publicité
Les langues disponibles
Les langues disponibles
4.2.
Air supply adjustment
For the supply of combustion air, the stove is equipped with three vents at the rear,
of which two are adjustable by means of two levers at the bottom of the front panel
of the stove (see picture). Through special air ducts, primary air (1) is led to the bot-
tom of the combustion chamber and passes through the ash removal port. Secon-
dary air (2) reaches the top of the glass panel. Permanent air supply to the rear side
of the combustion chamber (3) under the flame plate assures perfect post-
combustion.
3
2
1
4.3.
Lighting a fire
In order to create sufficient draught and to prevent smoke from being emitted into
the room, the chimney should be warm enough before lighting a fire. A cold chim -
ney can be heated up by lighting a ball of paper above the fire plate.
To kindle the fire in the stove you can use paper and/or firelighters and small pieces
of wood.
Slightly open the door and turn the air slides wide open.
It is important that the kindled fire should burn intensely. You can then throw larger
pieces of wood onto the fire, and close the doors. When the fire has eventually stabi-
lized and is glowing enough, you can put the logs or the brown coal briquettes on
the fire.
4.4.
Burning wood
The best way to control the fire is to completely close the primary air slide, which
you use to get the fire started, and to regulate the air supply with the secondary air
slide only. In case the air supply through the secondary air slide seems insufficient,
or if you would like to fan the fire, you can partially open the primary air slide for a
while.
Always keep the stove doors tightly closed. Never leave the doors open when the fire
is burning.
640CB - 760CB
1
: primary air
1
: secondary air
2
• = open Ä = close
25
2
03.27999.000
Publicité
