Publicité
Les langues disponibles
Les langues disponibles
3.2.2. Assembling the "cold handle"
Assemble the different parts of the handle, i.e. a screw
M8x50, a wooden handle and a nut, as indicated on the
sketch.
3.3.
Finishing
When the stove is placed in the final position and hermeti-
cally connected to the chimney, you can replace all of the loose parts.
Your stove is now ready for use.
Attention: never light a fire with the inner plates or refractory stones removed.
3.4.
Packaging materials
Packaging materials should be disposed of in a responsible way and in accordance
with governmental regulations.
4.
Instructions for use
4.1.
Fuel
The only suitable fuel for this stove is wood. No other fuels are allowed to be burnt,
as they can inflict serious damage to your stove.
Do not burn any treated wood such as scrap wood, dyed wood, impregnated or pre-
served wood, plywood or chipboard. The fumes of these, as of synthetic materials,
old papers and household waste, are highly polluting for both your stove, your chim -
ney, and for the environment. They also could cause chimney fires.
Wood
Hard woods, such as oak, birch- and fruit-trees, are the ideal fuels for your stove.
The wood must have dried for at least two years in a covered and well-ventilated
place. Split logs will dry faster. Dry wood should contain no more than twenty pe r-
cent moisture.
Wet logs are unsuitable for burning, as they do not produce enough heat and all of
the energy is lost in the process of evaporation. Moreover, the burning of wet wood
causes badly smelling gases to be released and a thick layer of tar will deposit on
the stove panels and in the chimney.
640CB - 760CB
24
03.27999.000
Publicité
