Philips sonicare HX9992/42 Mode D'emploi page 13

Brushing modes
5 Apply light pressure to maximize Philips Sonicare's
effectiveness and let the Philips Sonicare toothbrush
do the brushing for you.
Note: The bristles should slightly flare. Do not scrub. A
change in vibration from the handle and the brushing
feedback light flashes purple to alert you when you
apply too much pressure.
Gently move the brush head slowly across the teeth in
a small back and forth motion so the longer bristles
reach between your teeth. Continue this motion
throughout the brushing cycle.
6 To clean the inside surfaces of the front teeth, tilt the
brush handle semi-upright and make several vertical
overlapping brushing strokes on each tooth.
7 The BrushPacer divides the brushing time into six
equal segments and indicates when you should move
to the next area. Segments are indicated with a brief
pause in vibration. The toothbrush automatically
stops at the end of the brushing session.
Note: Your Philips Sonicare toothbrush is safe to use on
braces, dental modifications and dental restorations
(fillings, crowns, veneers)
Your power toothbrush comes pre-set to the all-in-one
clean mode that provides the dentist recommended 2
minute brushing routine, with a six segment brush pacer.
To personalize your brushing mode you can customize
your power toothbrush settings from the Sonicare app
(see 'Sonicare App - Getting Started').
Note: Although a mode is not displayed on the
toothbrush handle, you can update the mode any time
from the Sonicare App and your selection will be stored.
13
English