Télécharger Imprimer la page

KWC ACLX1001 Notice De Montage Et De Mise En Service page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

11.13 Connect the red plug to the solenoid valve cartridge for hot water.
The battery compartment and battery or power pack are not included in the delivery
(see
Chapter
11.14 If a power pack is used, unscrew the blind plug (f)
11.15 Mount the cable screw (h).
11.16 Route the plug (j) into the lower part of the housing through the cable screw (h).
11.17 Connect the sensor (l) with
– the battery compartment (k)
or
– the power supply (g).
If the battery charge state is low, the LED flashes in
a 20-second cycle.
11.18 Fold the front cover (d) up.
11.19 Press the cap (b) onto the front cover (d).
11.20 If using a power pack, connect the power pack to the power supply.
12. Function
The remote control is not included in the scope of delivery (see
Accessories).
Hygiene Flush
The hygiene flush has been factory-set in such a way that water will flow for 3
minutes every 24 hours once the supply voltage has been connected. Both solenoid
valve cartridges are opened.
Start Hygiene Flush
12.1 Select the following menus on the remote control
– Franke
– Sensor function
– 8X Hygiene unit functions
12.2 Select the menu point "Hygiene Flush".
12.3 Press the "OK" button.
12.4 Press the
• The sensor flashes green once.
• Water will flow for the pre-set time.
The hygiene flush can be switched off with the remote control or the 2-button remote
control (not part of the scope of delivery, see
19.).
button.
Chapter
19., Accessories).
- 8 -
Chapter
19.,

Publicité

loading

Ce manuel est également adapté pour:

Aclx100320300689852030068986