Télécharger Imprimer la page

Atag WU11PM Serie Mode D'emploi page 65

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION
Montage
Building in the extractor hood
• Remove the edge-extractor panel:
- Flip the edge-extractor panel downwards.
- Release the latch cables by turning the bayonet catch 180
degrees.
- Disconnect the connectors from the electricity cable.
Remove the edge-extractor panel from the extractor hood.
• Put the plug of the extractor hood in the socket.
• Connect the 7-pole connector to the 7-pole connector of the
external motor (WU11..PX/WU15..PX).
• Position the extractor hood in the hole and slide the 4 sliding pieces
outwards from inside the hood. The extractor hood should remain
hanging.
• Secure the extractor hood to the joists or to the ceiling using the
screws provided and the holes intended for this purpose.
• Refit the edge-extractor panel.
Do not forget to reconnect the electric cable connectors and to
pull the cables taut so they do not get caught in the hinge.
EN 17

Publicité

loading

Ce manuel est également adapté pour:

Wu11px serieWu15px serieWu1111pmWu1150pmuu/a2Wu1111px