Electrolux EI30ES55LB Instructions D'installation page 3

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top around the cut-out should be fl at and
1
leveled (see hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2)
2
cabinet sides (H1-4), front and back (see illustration 1) from the
fl oor to the top of the counter.
Level the range using
the two (2) front leveling
legs and the two (2)
adjustable leveling wheel,
3
so that the height from
the fl oor to the underside
of the metal fl ange is
greater than the tallest cabinet measurement by
at least 1/16" (see illustration 2).
Remove and discard the two rear leveling legs,
4
they are only in place to solidify the unit for the transport.
Slide the unit into the cabinet. Make sure the center of the unit is
5
aligned with the center of the cabinet cut-out.
Remove the protective channels on each side of the cooktop
6
(if provided).
The metal fl ange under each side of the cooktop MUST be
placed over the cabinet countertop for proper unit support.
7
The cooktop should NOT rest directly on the countertop (see
illustration 2) or else it could cause damage to the cooktop
voiding the warranty. Level the unit if needed.
After the installation, MAKE SURE that the
unit is supported by the two front leveling
8
legs and the two adjustable leveling wheels
and NOT by the cooktop.
1 ½" Max.
Shave
(3.8 cm Max.)
Raised
Edge
to Clear
Space for a
31½" (81 cm)
Wide Cooktop.
3
H2
H1
H3
Illustration 1
Illustration 2
H4
To successfully install
the range, the initial
level height from
floor to underside
of cooktop frame
should be at least
1/16" taller than
cabinet sides as
measured in step 2.