Electrolux EI30ES55LB Instructions D'installation page 11

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
8
Anti-Tip Brackets Installation
To reduce the risk of tipping of the
range, the range must be secured to the fl oor by properly
installed anti-tip bracket and screws packed with the
range. These parts are located in the oven. Failure to
install the anti-tip bracket will allow the range to tip over
if excessive weight is placed on an open door or if a child
climbs upon it. Serious injury might result from spilled hot
liquids or from the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8"(0,32 cm) bit
5/16" (0,8 cm) Nutdriver
Level
The anti-tip bracket attaches to the fl oor (or back wall)
at the back of the range to prevent range from tipping.
When fastening bracket to the fl oor, be sure that screws
do not penetrate electrical wiring or plumbing. The screws
provided will work in either wood or concrete.
O F
G E
R
E O
E D
I N
C K
E L
B A L
A L
N G
R A W
A R
R E
C L
10 ¼
(26.04 cm)
ANTI-TIP
BRACKET
C
( L = Center line)
L
A L
W
A R
R E
Figure 11
Kitchen
Cabinet
Door
Toe
Cabinet
Plate
"
SLIDE
BACK
1. Draw a center line (CL) on the fl oor where the range
should be installed. Also draw a line on the fl oor at
the range back position if there is no wall.
2. Unfold paper template and place it fl at on the fl oor
with the right rear corner positioned exactly on the
intersection of the center and back lines you just drew
before. (Use the diagram below to locate brackets if
template is not available. (Figure 11))
3. Mark on the fl oor (or wall) the location of the
mounting holes shown on the template. For easier
installation, 3/16"(0,48 cm) diameter pilot holes
1/2"(1,27 cm) deep can be drilled into the fl oor (or
wall).
4. Remove template and place bracket on fl oor. Line up
holes in bracket with marks on fl oor/wall and attach
with screws provided. Bracket must be secured to solid
fl oor or wall (Figure 12). If attaching to concrete fl oor,
fi rst drill 3/16"(0,48 cm) dia. pilot holes using masonry
drill bit.
5. Be sure the 4 levelling legs are at the highest position
they can be.
6. Slide range into place making sure structure of the
range is trapped by the anti-tip bracket (Figure 11).
Lower the range by adjusting the 4 levelling legs until
the underside of the cooktop is sitting level on the
countertop. Refer to "Levelling the Range" section.
7. After installation, verify that the anti-tip bracket is
engaged by grasping the top rear edge of the range
and carefully attempt to tilt it forward to make sure
range is properly anchored.
Range
Floor
Floor Mount
11
Anti-Tip Bracket
Figure 12
Wall
Mount